<< Back to Main KP3S site

Select Creality -> Ender 3 as your device and make the following changes

Start GCODE

; Ender 3 Custom Start G-code
M501 ; load EEPROM settings
G92 E0 ; Reset Extruder
G28 ; Home all axes
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X0.1 Y100.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X0.2 Y100.0 Z0.3 F5000.0 ; Move to side a little
G1 X0.2 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
; M501 ; Restore settings from EEPROM
; M420 S1 ; Load bed leveling data if you have BL touch; use G29 if you would 
; rather level 
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

Stop GCODE

; KP3S changes were Y150 (don't move up as much as Ender)
G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G90 ;Absolute positionning
G1 X0 Y170 ;Present print
M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bed
M84 X Y E ;Disable all steppers but Z

<< Back to Main KP3S site